Combining Vials MOTS0c
-
https://www.youtube.com/watch?v=XRzzwToLSiY&t=2s
Randy has a good video on this! use the calculator, depending on your dosage I would consider 3/3ml give you 1mg dose in 10 units. I used one vial on my rat until I got up to 1mg daily dose.
@brandenscheidecker
I'm interested how you determined 1mg daily to be the dosing your rat needed? -
Great idea, @commander I am taking 3.33mg, three times per week.
-
@brandenscheidecker
I'm interested how you determined 1mg daily to be the dosing your rat needed?@Stan-Douglas https://community.peptidecritic.com/topic/349/mots-c-subcutaneous-research-dosing-protocol
I started with 1- 10ml bottle and titrated up to 1mg per day, I used syringes on my first bottle, so I don't waste a pen cart. I got a kit of 10 bottles, so it makes using the other 9 bottles easy. My Rat takes this with 50mg of NAD+ and he is wired for several hours.
-
I reconstituted 3 separate vials with 1ML BAC water in each. Put them in my 3ML cartridge and loaded up my pen. Thanks, everyone!
-
@commander I have done it both ways and I think it’s easier to do 3 ml in one vial, then transfer like Randy does in the video. Obviously it’s up to your preference.
Either way, you can load it up the way you want. I have stuffed up to 7 vials into one pen cartridge.
-
The challenge if you are doing a lot of vials is trying to dissolve them all with less than 1ml bac water. I forgot to say that above.
-
They all dissolved fairly easily. I used just a "smidge" less than 1ML in the vials, to make sure that I had room. It barely fit and there was hardly any air to push out at the end.
