AOD9604 reconstitution
-
There are a couple guides up if you search for them. But the jist that I've read is that you want to pull a vacuum in the vial after you put in your solution. Acid will just ruin your peptide so don't add that.
You also NEED everything to be room temperature, and I've seen lots of posts recommending to use small doses like 5mg, because the higher the dose the more troublesome the reconstitution is.
-
Thank you for the reply! I been looking up different ways I seen online with acidic acid to using hosperic bac water. I was just seeing if anyone on here has their experience with this if they can share tips and advice. I shouldn’t of went with the 10 mg vials that’s my mistake.
-
Thank you for the reply! I been looking up different ways I seen online with acidic acid to using hosperic bac water. I was just seeing if anyone on here has their experience with this if they can share tips and advice. I shouldn’t of went with the 10 mg vials that’s my mistake.
Must be room temperature. Use 3ml of HOSPIRA Bac water for your 10mg vials. Inject slowly down the side of the wall of the vial. Once you have added all the vac water lift the syringe up a bit so it’s sitting above the liquid solution. Now pull back on the plunger of the syringe drawing back out as much air as you can from
the vial to create a vacuum. Then pull the syringe out and gently roll the vial back and forth in between your hands a few times and then let it sit. Then roll again a few times and let it sit. I do this for about 10 or 15 mins and I haven’t had a vial of AOD gel ever since. -
I hope you didn't toss the gelled vial away, you can palm it for a few minutes and it will liquefy again.
I never left my AOD, out I would just palm it every morning. I hear Tesa has the same gelling problem and I leave that in a dark closet now and have never had it gel. -
I had 10mg vials from 2 different vendors. Both gelled. But they were cloudy when gelled, so I wouldn’t have used them. I am not sure they were completely at room temp and I didn’t try the maintaining a vacuum thing.
I wonder if this is why Nexaph only sells 2mg vials. Alpha Biolabs also had difficulty making high concentration vials that wouldn’t gel, but they said they finally got the ph right on the large concentrations.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login