What 3D printer should I order and lets put some files here

[afkar7]

@Stevepep said:

@randy had to do it. It works great but totally unnecessary.

I tried this one and it would not work for me. Now I was just testing it by turning it with my hand but it just wouldn’t move. It was like it was to tight. I’m going to try again at some point.

[Stevepep]

@afkar7 I did the motor today, and when I tried the motor counter clockwise, it kept getting stuck I switched the terminals to clockwise, and it ran fine. That is some serious design work by the guy who shared that file

[Randy]

@afkar7 i used some clp gun lube on the joints to get it moving.

[afkar7]

@Randy said:

@afkar7 i used some clp gun lube on the joints to get it moving.

Thanks

[Stevepep]

I had to update the file for the travel cooler I created. It got corrupted and wasn't showing the full print file, so here we go again. My wife thinks it was the person who stole it twice and was listing them on Etsy. So here it is, and it works great. Holds 2 pens, two pen vials, a cooler pack (the link is on makers), and syringes in a screw-off lid.

https://makerworld.com/en/models/3065513-travel-cooler-for-insulin-peptide-pen#profileId-3450401

[afkar7]

@stevepep

Just wondering. Did the gears keep backing out on you and if so, what did you do to keep that from happening?

[Stevepep]

@afkar7 you have to glue the ones that don’t clip in. I just put a drop of glue be carful not to glue the rollers to the frame. I also glued the motor. Little trial and error but it works great. NAD was a real pain I just put it on that for a couple of minutes and it worked terrific

[afkar7]

@Stevepep said:

@afkar7 you have to glue the ones that don’t clip in. I just put a drop of glue be carful not to glue the rollers to the frame. I also glued the motor. Little trial and error but it works great. NAD was a real pain I just put it on that for a couple of minutes and it worked terrific

Figured but just wanted to check, thanks. I was surprised how quick it turned with that 150rpm motor.

[afkar7]

Yeah it’s a bit extra but what the heck.

[user_15228]

I am glad i found this post, i love 3D printing. Anyone find a good file for a pen cap dispenser only?