Peptide Critic Community

@vpeptides This might make you think twice about "FDA approved" https://www.fda.gov/drugs/human-drug-compounding/compounding-inspections-recalls-and-other-actions

You may take a blood test for IGF-1 to see how your current protocol affects you. Usually 120 to 200 ng/mL is the normal range with about 160 to be optimal. Your base line may be 120-130, you would need to measure it outside of your research cycles. If you get it a lot over 200 it may be too much and have side effects for your health, probably something in the range of around 200 is OK for the protocol temporarily.

U guys are probably right, but I still stocked up on everything I’ll need through November or later just to be sure lol.

Good list. Depending on how anal you are about getting every drop out of reconstituted vials, you can also buy 30/31 gauge 1.5” needles to move from the vial to the cart.

But, again vendors COAs don’t really mean anything. Third party tests are better. Testing yourself is the best...

Thanks guys, started with an elbow and will probably do that locally for a week then rotate to heel, then knee. Rinse and repeat. Pretty much benign supplements. D3+K2, Mg glycenate, Niacinamide, B12, sawgrass. Not expecting any of them would do worse than with normal digestive juices and anti inflammatory bits.

I have not found any references to whether subject mass should be considered when determining dosing. I mean, the 200unit mass wabbit can drink 2 beers before anything noticeable and the 100unit wabbit bumps into walls after 1. If using recommendations from PeptideDosages.com, are these a recommended starting point, are they good for a 100unit and a 600unit subject? Don't want to kill the wabbit.

You probably hit a blood vessel and there was slight vacuum in the vial (assuming you keep it in the fridge) so before you hit the plunger, it drew some blood into the vial. I have had this happen with syringes but not vials(yet.) Part of the reason i use short needles (4-6mm) is that with syringes or longer needles 8mm+ i hit vessels and get a lot of bruising. Still happens but much less often.

@PeptideEd said: @neil-mccauley would you be willing to start a thread detailing your experiences? I'm just starting to get into Tesa/Ipa and would love to hear about your experience, what sorts of labs you run, and what you've learned! Me too! Before I learned from Randy/Jeff how to DIY, I've been taking already reconstituted Tirz and NAD+ in the fridge for over 90 days and no problems with potency at all. Can't say the BAC is protected, but no deleterious effects that I can feel; no doubt the additives, B12, glyc. Don't need either of those; not sure the B12 is methylated, probably not, IDK. Feeling isn't everything.

@ResearchCat said: I have the same thing happen. I assume it’s because the vials are kept cold so the liquid volume shrinks and when I insert the needle, it draws a small amount of air into it. Probably also why sometimes the needle drips a little as it warms up. This doesn’t happen all the time for me. Oddly of the three pens I am running right now, only one is doing this. Hey, Thanks for the reply. Yes also the dripping issue is relatable - i didn't mention it in my initial post. I'll try next week filling some pens with "cold" vials - to see what' s what. I've also ordered a new batch of vials from a more allegedly more reputable manufacturer. Thanks,

Hey guys! Just like the title says, are there any reputable vendors that ship Bac water to Germany?

Update: I added some ironing settings that seemed to have helped the 'preview' image look better. This whole thing is a bit of a learning curve even without designing it myself. I'll get it though...this is gonna be fun!

There is an app called Peptide tracker which I have found to be great. There is some setup time to load everything but it works well

@emkay I am addicted to pens teh xulin is great

you could add 3ml to your vial and draw out your dose into syringes ahead of time, then draw out additional bac water into the syringe to dilute further.

Hi & welcome. I’m from Aus & very few of the USA based resellers will send to Aus - not just peptides but peptide related products like pens, needles, BAC, ETC. Also in a lot of cases even if they do will also only accept either crypto or forms of payment that are either not available or very uncommon over here. If you are OK with crypto you have many more options open to you but they’ll mostly be Chinese. Being scammed is the biggie - and you probably will unfortunately - you’re dealing with Chinese drug dealers so……….. My advice is to read read read & read some more at stalker like levels for weeks minimum (I did for months) places like here to get a feel for how it works before you attempt to go grey - you’ll probably also learn quite a bit about things that you really should know about before you start sticking Chinese drugs in your guts ie dosing reconstitution storage etc. I’ve got a few now that I’m comfortable with and have put small test orders through first including a couple that have Aus warehouses (sheds, bedrooms, cupboards ‍️) but I could just be a scammer too If you do that you’ll find what you’re looking for but definitely don’t believe everything outright especially people dming you have a high likelihood of being scammers. This place is much more legit & professional than most other places on the net though so a lot safer to an extent and you’ll learn a lot.

@Stevepep Im glad I did

Ive never filtered. Only learned about it through this page. Tbh

@damic dm me details

Thank you Eleanor. Im wanting to research glp3, Tesamorelin and perhaps GHK-cu. I’ll add further tags and see how that goes but I know being in Aus is probably a problem with this research as few people talk about it openly.